3 Oval Pool Installation Mistakes To Avoid

3 Oval Pool Installation Mistakes To Avoid

pool installationLet us not waste any time. Let us get down to business right away. Let us discuss the top three pool installation mistakes you have to avoid at all cost.

Common Pool Installation Blunders You Need To Know

Incorrect Installation Of The Side Braces

There are many different designs of oval swimming pools it is hard to be very specific, but in most instances, following the instructions to the tee almost always offer great results. Your most important goals are to set up all of the braces and square them before you begin digging. Dig out what you have to and without too much digging. It is better to have less back fill. Your oval swimming pool side braces must be perfectly level in both front and back portion. They must all be square on each side and on a certain side, they must all be touching a string line. On then must the dirt be packed back in around all them.

An oval swimming pool will begin to really funny when the braces on a certain side are not square with the braces on the other side. It begins to look even funnier if one side isn’t straight, like resting flush in a string line. That would imply that the other side isn’t straight either. When they go in and out a little, up or down a little, things will begin to look really weird. The correct use of a laser level, a string line, as well as a tape measure is going to take care of this typical error.

Covering The Pressure Plates and Straps Incorrectly

A lot of people ask about indentations in the liner surrounding the braces assemblies inside the swimming pool. This could be a major issue, meaning the swimming pool is not safe and requires to be drained so necessary fixes can be made. The liner can’t sit on the bare metal of everything, there should be a cushion. The problem is commonly ground settling around the brace channels or the pressure plates. The water’s weight when the pool becomes full is tremendous, what you place under it should be solid. This implies not just back filling surrounding the brace assemblies, but packing it solid. If required, water, wait, and then pack some more.

The other mistake isn’t covering the pressure plates with sufficient sand. A few of these things are big and most of them possess sharp edges, they are extremely important to the swimming pool’s integrity, and can’t be left out, however, they should be well covered. Keep in mind, the water’s weight increases as the swimming pool fills, whatever is on top of those plates will compress. Sand will not just compress it but it will also shift into huge openings, such as those made at the ends of pressure plates. Make certain that your side brace assemblies are well covered and packed.

Blocking The Sides Braces Incorrectly

The weight of the water, when it pushes out on the walls of the swimming pool just like it pushes down on the floor. That is why using a concrete block underneath the back of every brace is crucial. Just as crucial, these blocks have to be set correctly level as well as on firm ground. Although the braces may appear fine before you add the water, when the blocks aren’t level and solid, the braces would push out once the pools fills, and they will never push out the same, leaving the side of your pool going in and out, which doesn’t look like it’s been professionally made. If you are trying an oval above ground pool installation Myrtle Beach on your own, make certain that you spend the time needed to correctly set the side braces.

Call Russell Cooper Pools if you have decided to work with an expert in installing your oval above ground swimming pool.

Russell Cooper Pools
101 Folly Rd.
Myrtle Beach, SC 29588
(843) 293-6757
myrtlebeachpoolbuilders.com